Respecting Your Router
Jan 16 2022 @ 8 PM ET / 5 PM PT w/Ben (@bens_diy)
- Started Jan 16Started Jan 16
*This class is currently full. If you you would like to be added to the waitlist, please fill out the form found here: https://www.melissagarchiediy.com/m2labswaitlist If we generate enough additional interest, we will explore more options* This class is all about routers, covering all the capabilities your trim router provides. Daddos, Rabbets, Round-overs, Mortises, and more! We will walk through router setup and safety, as well as the types of bits and bearings, and how to use them. The projects for this class will be a mitered and mortised frame with a beveled edge. Inside the frame will be a square tongue and groove insert that fits inside the frames mortise. The material list for this class will be sent one week in advance. Requirements: 1. You must follow @bens_diy, @m2.labs, @mikebuiltsomething & @melissagarchiediy. 2. If you take part in the Instagram group chat, it is strongly encouraged that you follow the other participants. 3. This is no posting requirement for this class. However, if you do, please tag the following: @bens_diy, @m2.labs, #huntingforrabbets 4. Failure to complete any of the above may result in the inability to enroll in future m2.Labs classes. Please note the tagging requirements may change as we get closer to the class. If that happens, you will be notified and it will be updated here.
San Diego, CA, USA